Denso GT20Q-SB User Manual page 109

(12) Beeper, Indicator LED, Vibrator, Marker, Illumination Light
Settings
Beeper sound
Beeper tone
Beeper sounding time
Beeper volume
Scanning complete sound
Beeper sound when power turned on
Indicator LED illumination
Vibrator
Marker illumination
Illumination light (LED)
Illumination light (LED) ECO mode
Note 1: As the brightness of the illumination LED is restricted, users will need to scan at close proximity in dark areas.
(13) Specifying Data Verification and Data Editing Conditions
Settings
Scan lock
Data verification mode verification
target
Preset master registration
Parameters
Enabled
Disabled
Low (approx. 2.5 kHz)
Medium (approx. 3.0 kHz)
High (approx. 3.5 kHz)
Short (approx. 60 ms)
Medium (approx. 80 ms)
Long (approx. 120 ms)
High
Medium
Low
Single beep
Multiple beeps
Enabled
Disabled
Enabled
Disabled
Vibrates when "OK"
Vibrates when "NG"
Vibration disabled
Marker-off mode
Standard marker mode
Marker-on mode
Disabled
Enabled
Enabled (Note 1)
Disabled
Parameters
Enabled
Disabled
Data string verification
Data block verification
Enabled
Disabled
96
Default



Section 8.1




Section 8.2

Section 8.3

Section 8.4
Section 8.5


Section 8.5
: Only available via configuration software.
Default



Refer to
Refer to
Section 7.1