Denso GT20Q-SB User Manual page 74

Code 39
The scanned data is transmitted as is.
You can select whether or not to transmit the start-stop codes. Start-stop codes are "*".
Interleaved 2 of 5, Standard 2 of 5
The scanner transmits scanned code data, starting from the character following the start code to the one preceding the stop
code.
Note that the start-stop codes will not be transmitted.
Codabar (NW-7)
The scanned data is transmitted with the start-stop codes included.
You can select whether or not to transmit the start-stop codes.
Code 128 (GS1-128)
The scanner transmits scanned code data, starting from the character following the start code to the one preceding the check
digit. Note that the start-stop code, FNC code, and check digit are not transmitted.
FNC1 in the first and second positions after the start code will not be transmitted. For FNC1 in other positions, the user can
select between the following options: disable transmission/conversion to <GS> (1Dh) and transmission/user selection.
You can also select whether or not to convert to GTIN format. (Refer to
GTIN format.)
Code 93
The scanned data is transmitted without the start-stop codes and check digit.
GS1 DataBar
The scanned data is transmitted as is.
For GS1 DataBar Expanded FNC1, the user can select between the following options: disable transmission/conversion to
<GS> (1Dh) and transmission/user selection.
You can also select whether or not to convert to GTIN format. (Refer to
GTIN format.)
GS1 DataBar Composite
The scanned data is transmitted as is.
If the scanner is set to "Code mark type: Type 1" and "Code mark output mode: Separating," a separator <GS> (1Dh) and 2D
code mark will be applied between the linear code data and 2D code data. (For details on the code mark applied, refer to
Section 9.4 (5))
If the scanner is set to "Code mark type: Type 4" and variable linear component (GS1 DataBar) code length, a separator
<GS> (1Dh) will be applied between the linear code data and 2D code data.
UPC/EAN Composite
The scanned data is transmitted as is.
If the scanner is set to "Code mark type: Type 1" and "Code mark output mode: Separating," a separator <GS> (1Dh) and 2D
code mark will be applied between the linear code data and 2D code data.
If the scanner is set to "Code mark type: Type 4," a 2D code mark will be applied between the linear code data and 2D code
data. (For details on the code mark applied, refer to
Section 9.5
Section 9.5
Section 9.4 (5))
61
for details on enabling conversion to
for details on enabling conversion to