Sony Handycam DCR-PC105 Operating Instructions Manual page 88

Dubbing only desired scenes – Digital program editing (on tape)
Step 2: Setting the VCR to operate
When you are connecting the camcorder and VCR using the A/V connecting cable, the
signal is emitted from the infrared rays emitter of your camcorder to the remote sensor
on the VCR to control the VCR.
The POWER switch should be set to
Operate by touching the panel.
(1) Turn the power of the connected VCR on. If the VCR has an input selector, set
(2) Press FN to display PAGE1.
(3) Press MENU.
(4) Select VIDEO EDIT in
(5) Select TAPE, then press EXEC.
(6) Press EDIT SET.
(7) Select CONTROL, then press EXEC.
(8) When connecting with the A/V connecting cable, select IR, then press EXEC.
(9) Select IR SETUP, then press EXEC.
(10) Select the IR SETUP code of your VCR, then press EXEC. Check the code in
(11) Select PAUSEMODE, then press EXEC.
(12) Select the mode to cancel record pause on the VCR, then press EXEC.
88
it to input mode.
When connecting with the i.LINK cable, select i.LINK, press EXEC, then go to
"Step 3: Adjusting the synchronization of the VCR" on page 92.
"About the IR SETUP code" (p. 91).
The correct button depends on your VCR.
Refer to the operating instructions of your VCR.
.
, then press EXEC.