Sony Handycam DCR-PC105 Operating Instructions Manual page 235

Identifying parts and controls
Replacing the button type lithium battery
(1) Pull out the battery holder while pushing the tab on the holder.
(2) Take out the button type lithium battery from the holder.
(3) Put a new battery into the holder with its + side facing upward.
(4) Insert the holder into the Remote Commander until it clicks.
1
WARNING
Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
Notes on the Remote Commander
•When the lithium battery becomes weak, the operating distance of the Remote
Commander may shorten, or the Remote Commander may not function properly. In
this case, replace the battery with a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
•A button type lithium battery (CR2025) is already installed in the Remote
Commander. Do not use any batteries other than CR2025.
•Point the remote sensor away from strong light sources such as direct sunlight or
overhead lighting. Otherwise, the Remote Commander may not function properly.
•Your camcorder works in the Commander mode VTR 2. Commander modes 1, 2 and 3
are used to distinguish your camcorder from other Sony VCRs to avoid erroneous
remote control operation. If you use another Sony VCR in the Commander mode VTR
2, we recommend changing the Commander mode or covering the sensor of the VCR
with black paper.
2 3 4
235