Speed Control - If Equipped; To Activate; To Set A Desired Speed; To Deactivate - Jeep Compass Operating Information Manual

WARNING!
Fluid level should be checked on a level
surface and with the engine off to prevent
injury from moving parts and to ensure accu-
rate fluid level reading. Do not overfill. Use
only manufacturer's recommended power
steering fluid.
If necessary, add fluid to restore to the proper
indicated level. With a clean cloth, wipe any
spilled fluid from all surfaces. Refer to "Fluids
And Lubricants" in "Technical Specifications" for
further information.
SPEED CONTROL — IF
EQUIPPED
When engaged, the Speed Control takes over
accelerator operations at speeds greater than
25 mph (40 km/h).
The Speed Control buttons are located on the
right side of the steering wheel.
136
Speed Control Buttons
1 — ON/OFF 3 — SET -
2 — RES + 4 — CANCEL
NOTE:
In order to ensure proper operation, the
Speed Control System has been designed to
shut down if multiple Speed Control func-
tions are operated at the same time. If this
occurs, the Speed Control System can be
reactivated by pushing the Speed Control
ON/OFF button and resetting the desired
vehicle set speed.

To Activate

Push the on/off button. The cruise control indi-
cator light in the instrument cluster display will
illuminate. To turn the system off, push the on/off
button a second time. The cruise control indica-
tor light will turn off. The system should be
turned off when not in use.
WARNING!
Leaving the Speed Control system on when
not in use is dangerous. You could acciden-
tally set the system or cause it to go faster
than you want. You could lose control and
have an accident. Always leave the system
off when you are not using it.

To Set A Desired Speed

Turn the Speed Control on. When the vehicle
has reached the desired speed, push the SET
(-) button and release. Release the accelerator
and the vehicle will operate at the selected
speed.
NOTE:
The vehicle should be traveling at a steady
speed and on level ground before pushing
the SET (-) button.

To Deactivate

A soft tap on the brake pedal, pushing the
CANCEL button, normal braking or pressing the
clutch pedal while slowing the vehicle will deac-
tivate Speed Control without erasing the set
speed memory. Pushing the ON/OFF button or
turning the ignition switch OFF erases the set
speed memory.