Uconnect Phone Features - Jeep Compass Operating Information Manual

Making A Second Call While Current Call Is
In Progress
To make a second call while you are currently on
a call, push the Voice Command
say "Dial" or "Call" followed by the phone num-
ber or phonebook entry you wish to call. The first
call will be on hold while the second call is in
progress. To go back to the first call, refer to
"Toggling Between Calls" in this section. To
combine two calls, refer to "Conference Call" in
this section.
Place/Retrieve A Call From Hold
To put a call on hold, push the Phone
until you hear a single beep. This indicates that
the call is on hold. To bring the call back from
hold, push and hold the Phone
you hear a single beep.
Toggling Between Calls
If two calls are in progress (one active and one
on hold), push the Phone button until you
hear a single beep, indicating that the active and
hold status of the two calls have switched. Only
one call can be placed on hold at a time.
Conference Call
When two calls are in progress (one active and
one on hold):
1. Push and hold the Phone
hear a double beep, indicating that the two
calls have been joined into one conference
call.
220
Three-Way Calling
To initiate three-way calling, push the Voice
Command
button and and make a second phone call, as described
under "Making a Second Call While Current Call
is in Progress." After the second call has estab-
lished, push and hold the Phone
you hear a double beep, indicating that the two
calls have been joined into one conference call.
Call Termination
To end a call in progress:
1. Momentarily push the Phone
button
• Only the active call(s) will be terminated
and if there is a call on hold, it will become
the new active call. If the active call is
button until
terminated by the phone far end, a call on
hold may not become active automatically.
This is cell phone-dependent.
2. To bring the call back from hold, push and
hold the Phone
single beep.
Redial
To redial the last number called from your mo-
bile phone using Voice Command:
1. Push the Phone
button until you
2. After the "Ready" prompt and the following
beep, say "Redial."
• The Uconnect Phone will call the last num-
ber that was dialed from your mobile
phone.
button while a call is in progress,
button until
button.
button until you hear a
button to begin.
NOTE:
This may not be the last number dialed from
the Uconnect Phone.
Call Continuation
Call continuation is the progression of a phone
call on the Uconnect Phone after the vehicle
ignition has been switched to OFF. Call continu-
ation functionality available on the vehicle can
be any one of three types:
1. After the ignition is switched to OFF, a call
can continue on the Uconnect Phone either
until the call ends, or until the vehicle battery
condition dictates cessation of the call on the
Uconnect Phone and transfer of the call to
the mobile phone.
2. After the ignition is cycled to OFF, a call can
continue on the Uconnect Phone for a certain
duration, after which the call is automatically
transferred from the Uconnect Phone to the
mobile phone.
3. An active call is automatically transferred to
the mobile phone after the ignition is cycled
to OFF.

Uconnect Phone Features

Language Selection
To change the language that the Uconnect
Phone is using:
• Push the Phone
button to begin.