Power Door Locks - Jeep Compass Operating Information Manual

WARNING!
• For personal security and safety in the
event of an collision, lock the vehicle doors
as you drive as well as when you park and
leave the vehicle.
• Never leave children alone in a vehicle, or
with access to an unlocked vehicle. Allow-
ing children to be in a vehicle unattended is
dangerous for a number of reasons. A child
or others could be seriously or fatally in-
jured. Children should be warned not to
touch the parking brake, brake pedal or the
gear selector.
• Do not leave the key fob in or near the
vehicle, or in a location accessible to chil-
dren. A child could operate power windows,
other controls, or move the vehicle.
CAUTION!
Always remove the key fobs from the vehicle
and lock all doors when leaving the vehicle
unattended.

Power Door Locks

A power door lock switch is located on the
driver's and front passenger's door panel. Push
these switches to lock or unlock the doors and
liftgate.
NOTE:
To prevent from locking the key in the ve-
hicle, the power door lock switch will not
operate when the key is in the ignition and
either front door is open. A chime will sound
as a reminder to remove the key.
Driver Power Door Lock Switch
1 — Unlock Doors And Liftgate
2 — Lock Doors And Liftgate
Auto Lock Doors — If Equipped
The Automatic Door Lock feature default condi-
tion is enabled. When enabled, the door locks
will lock automatically when the vehicle's speed
exceeds 15 mph (24 km/h).
Auto Lock Doors Programming
The Automatic Door Lock feature can be en-
abled or disabled as follows:
• For vehicles equipped with the instrument
cluster display, refer to "Instrument Cluster
Display — If Equipped/Personal Settings
(Customer Programmable Features)" in "Get-
ting To Know Your Instrument Panel" for
further information.
• For vehicles not equipped with the instrument
cluster display, perform the following proce-
dure:
1. Close all doors and place the key in the
ignition.
2. Within 15 seconds, place the ignition be-
tween LOCK and ON/RUN and then back to
LOCK four times, ending up in the LOCK
position (do not start the engine).
3. Within 30 seconds, push the power door lock
switch to lock the doors.
4. A single chime will indicate the completion of
the programming.
5. Repeat these steps if you want to return this
feature to its previous setting.
NOTE:
• If you do not hear the chime, it means that
the system did not enter the programming
mode and you will need to repeat the
procedure.
• Use the Automatic Door Lock feature in
accordance with local laws.
25