Operation - Jeep Compass Operating Information Manual

as your phone is turned on and has been paired
to the vehicle's Uconnect Phone. The Uconnect
Phone allows up to seven mobile phones to be
linked to the system. Only one linked (or paired)
mobile phone can be used with the system at a
time. The system is available in English, Span-
ish, French, German, Italian, or Dutch lan-
guages.
WARNING!
ALWAYS drive safely with your hands on the
wheel. You have full responsibility and as-
sume all risks related to the use of the
Uconnect features and applications in this
vehicle. Only use Uconnect when it is safe to
do so. Failure to do so may result in an
accident involving serious injury or death.
Uconnect Phone Button
The radio or steering wheel con-
trols (if equipped) will contain the
two control buttons (Uconnect
Phone button and Voice Com-
mand button) that will enable
you to access the system. When you push the
button you will hear the word Uconnect followed
by a BEEP. The beep is your signal to give a
command.
216
NOTE:
The driver side upper windshield trim con-
tains the microphone for the Uconnect
Phone.
Voice Command Button
WARNING!
Any voice commanded system should be
used only in safe driving conditions following
all applicable laws. Your attention should be
focused on safely operating the vehicle. Fail-
ure to do so may result in a collision causing
serious injury or death.
Actual button location may vary
with the radio. The individual but-
tons are described in the "Opera-
tion" section.
The Uconnect Phone can be used with any
Hands-Free Profile certified Bluetooth mobile
phone. See the Uconnect website for supported
phones. Refer to your mobile service provider or
the phone manufacturer for details.
The Uconnect Phone is fully integrated with the
vehicle's audio system. The volume of the
Uconnect Phone can be adjusted either from the
radio volume control knob or from the steering
wheel radio control (right switch), if so equipped.
The radio display will be used for visual prompts
from the Uconnect Phone such as "CELL" or
caller ID on certain radios.

Operation

Voice commands can be used to operate the
Uconnect Phone and to navigate through the
Uconnect Phone menu structure. Voice commands
are required after most Uconnect Phone prompts.
You will be prompted for a specific command and
then guided through the available options.
• Prior to giving a voice command, one must
wait for the beep, which follows the "Ready"
prompt or another prompt.
• For certain operations, compound commands
can be used. For example, instead of saying
"Setup" and then "Phone Pairing," the follow-
ing compound command can be said: "Setup
Phone Pairing."
• For each feature explanation in this section,
only the compound form of the voice com-
mand is given. You can also break the com-
mands into parts and say each part of the
command when you are asked for it. For
example, you can use the compound form
voice command "Phonebook New Entry," or
you can break the compound form command
into two voice commands: "Phonebook" and
"New Entry." Please remember, the Uconnect
Phone works best when you talk in a normal
conversational tone, as if speaking to some-
one sitting a few feet/meters away from you.