Oil Change Indicator System; Instrument Cluster Display Functions - Jeep Compass Operating Information Manual

Down Arrow Button
Push and release the down arrow button to
scroll downward through the submenus.
When the appropriate conditions exist, the fol-
lowing messages display:
• Turn Signal On (with a continuous warning
chime after 1 mile (1.6 km) of distance trav-
elled)
• Left Front Turn Signal Lamp Out (with a
single chime)
• Left Rear Turn Signal Lamp Out (with a single
chime)
• Right Front Turn Signal Lamp Out (with a
single chime)
• Right Rear Turn Signal Lamp Out (with a
single chime)
• Battery Low (with a single chime)
• Personal Settings Not Avail. — Vehicle is not
in PARK (automatic transmission), or vehicle
is in motion (manual transmission)
• Door Open (with vehicle graphic showing
which door is open. A single chime sounds if
the vehicle is in motion)
• Doors Open (with vehicle graphic showing
which doors are open. A single chime sounds
if the vehicle is in motion)
• Gate (with vehicle graphic showing the lift-
gate open and a single chime)
64
• Headlamps or Park Lamps On
• Remote Start Aborted — Door Open
• Remote Start Aborted — Hood Open
• Remote Start Aborted — L/Gate Open
• Remote Start Aborted — Fuel Low
• Remote Start Aborted — System Fault
• Key In Ignition
• Low Tire
• Low Tire Pressure Display for Premium TPM
System
• Service TPM System

Oil Change Indicator System

Your vehicle is equipped with an engine oil
change indicator system. The "Oil Change Re-
quired" message will display in the instrument
cluster display for approximately five seconds
after a single chime has sounded to indicate the
next scheduled oil change interval. The engine
oil change indicator system is duty-cycle based,
which means the engine oil change interval may
fluctuate dependent upon your personal driving
style.
Unless reset, this message will continue to
display each time you place the ignition in the
ON/RUN position. To turn off the message tem-
porarily, push and release the Trip Odometer
button on the instrument cluster. To reset the oil
change indicator system (after performing the
scheduled maintenance), refer to the following
procedure.
1. Place the ignition in the ON position. Do not
start the engine.
2. Fully push the accelerator pedal, slowly,
three times within ten seconds.
3. Place the ignition in the OFF/LOCK position.
NOTE:
If the indicator message illuminates when
you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat
this procedure.
Instrument Cluster Display
Functions
• Compass/Temperature/Audio
• Average Fuel Economy
• Distance To Empty (DTE)
• Units In
• Elapsed Time
• Tire Pressure Monitor (TPM)
• Personal Settings
To Reset The Display
Pushing and holding the right arrow button
once will clear the function currently being dis-
played. Reset will only occur if a resettable
function is currently being displayed. To reset all