Automatic Transmission (Six-Speed) - If Equipped - Jeep Compass Operating Information Manual

Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 inch
(4.7 mm) below the bottom of the hole.
Add fluid, if necessary, to maintain the proper
level.
Please see your authorized dealer for service.
Frequency Of Fluid Change
Under normal operating conditions, the fluid
installed at the factory will give satisfactory
lubrication for the life of the vehicle. Fluid
changes are not necessary unless lubricant has
become contaminated with water.
NOTE:
If contaminated with water, the fluid should
be changed immediately.
Automatic Transmission (Six-Speed)
— If Equipped
Selection Of Lubricant (Six-Speed
Transmission)
It is important to use the proper transmission
fluid to ensure optimum transmission perfor-
mance and life. Use only the manufacturer's
specified transmission fluid. Refer to "Fluids And
Lubricants" in "Technical Specifications" for fluid
specifications. It is important to maintain the
transmission fluid at the correct level using the
recommended fluid.
190
No chemical flushes should be used in any
transmission; only the approved lubricant
should be used.
CAUTION!
Using a transmission fluid other than the
manufacturer's recommended fluid may
cause deterioration in transmission shift qual-
ity and/or torque converter shudder. Refer to
"Fluids And Lubricants" in "Technical Specifi-
cations" for fluid specifications.
Special Additives
The manufacturer strongly recommends against
using any special additives in the transmission.
Automatic Transmission Fluid (ATF) is an engi-
neered product and its performance may be
impaired by supplemental additives. Therefore,
do not add any fluid additives to the transmis-
sion. The only exception to this policy is the use
of special dyes for diagnosing fluid leaks. Avoid
using transmission sealers as they may ad-
versely affect seals.
CAUTION!
Do not use chemical flushes in your trans-
mission as the chemicals can damage your
transmission components. Such damage is
not covered by the New Vehicle Limited
Warranty.
Fluid Level Check
The fluid level is preset at the factory and does
not require adjustment under normal operating
conditions. Routine fluid level checks are not
required, therefore the transmission filler tube is
capped and no dipstick is provided. Your autho-
rized dealer can check your transmission fluid
level using special service tools. If you notice
fluid leakage or transmission malfunction, visit
you authorized dealer immediately to have the
fluid level checked. Operating the vehicle with
an improper fluid level can cause severe trans-
mission damage.
CAUTION!
If a transmission fluid leak occurs, visit your
authorized dealer immediately. Severe trans-
mission damage may occur. Your authorized
dealer has the proper tools to adjust the fluid
level accurately.
Fluid And Filter Changes
Under normal operating conditions, the fluid in-
stalled at the factory will provide satisfactory lubri-
cation for the life of the vehicle. However, if the
vehicle is frequently driven on rough or unpaved
roads, on mountain roads, on short trips, or in
heavy city traffic during hot weather, or is used for
frequent trailer towing, police, fleet, taxi, etc.,
change the fluid as indicated in the Service and
Warranty Handbook. In addition, change the fluid