Jeep Compass Operating Information Manual page 69

Hide thumbs Also See for Compass:
Table of Contents

Advertisement

PARK or NEUTRAL position (automatic trans-
mission). Push and hold the right arrow button
when in this display until "ON" or "OFF" appears
to make your selection.
Key Fob Unlock
When Driver's Door 1st is selected, only the
driver's door will unlock on the first push of the
key fob unlock button and require a second
push to unlock the remaining locked doors.
When Remote Unlock All Doors is selected, all
of the doors will unlock at the first push of the
key fob unlock button. Push and hold the right
arrow button when in this display until "Driver's
Door 1st" or "All Doors" appears to make your
selection.
Flash Lamps With Lock
When ON is selected, the front and rear turn
signals will flash when the doors are locked or
unlocked using the key fob. This feature may be
selected with or without the sound horn with lock
feature selected. Push and hold the right arrow
button when in this display until "ON" or "OFF"
appears to make your selection.
Sound Horn With Lock
When ON is selected, a short horn sound will
occur when the key fob lock button is pushed.
This feature may be selected with or without the
Flash Lights with Lock feature. Push and hold
the right arrow button when in this display until
"ON" or "OFF" appears to make your selection.
66
Headlamp Off Delay
When this feature is selected the driver can
choose to have the headlights remain on for 0,
30, 60, or 90 seconds when exiting the vehicle.
Push and hold the right arrow button when in
this display until 0, 30, 60, or 90 appears to
make your selection.
Headlamps With Wipers (Available With
Auto Headlights Only)
When on is selected, and the headlight switch is
in the AUTO position, the headlights will turn on
approximately ten seconds after the wipers are
turned on. If the headlights were turned on by
this feature, they will also turn off when the
wipers are turned off. To make your selection,
push and release the right arrow button until
"ON" or "OFF" appears.
NOTE:
Turning the headlights on during the daytime
causes the instrument panel lights to dim. To
increase the brightness, refer to "Lights" in
"Getting To Know Your Vehicle."
Key Off Power Delay
When this feature is selected the power window
switches, radio, Uconnect phone, power sun-
roof, and power outlets will remain active for up
to 10 minutes after the ignition switch has been
turned OFF. Opening either front vehicle door
will cancel this feature. Push and hold the right
arrow button when in this display until "OFF,"
"45 sec.", "5 min.", or "10 min." appears to make
your selection.
Illuminated Approach
When this feature is selected, the headlights will
activate and remain on for up to 90 seconds
when the doors are unlocked using the key fob.
Push and hold the right arrow button when in
this display until "OFF," "30 sec," "60 sec," or
"90 sec." appears to make your selection.
Hill Start Assist (HSA) — If Equipped
When "On" is selected, the HSA system is
active. Refer to "Electronic Brake Control Sys-
tem" in "Safety" for system function and operat-
ing information. To make your selection, push
and release the right arrow button until "On" or
"Off" appears.
Display Units In
The instrument cluster display, odometer, and
Uconnect GPS system units can be changed
between US and Metric.
Push and hold the right arrow button when in
this display until "US" or "METRIC" appears to
make your selection.
Automatic Compass Calibration
This compass is self-calibrating, which elimi-
nates the need to set the compass manually.
When the vehicle is new, the compass may
appear erratic, and the instrument cluster dis-
play will display "CAL" until the compass is
calibrated. You may also calibrate the compass
by completing one or more 360 – degree turns
(in an area free from large metal or metallic
objects) until the "CAL" message displayed in
the instrument cluster display turns off. The
compass will now function normally.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents