3.1 An Overview of I/O Allocation
3.1.1 Overview
The S-LINK unit, like other I/O units, uses inputs (X) and outputs (Y).
The inputs/outputs on the FPΣ side are treated as corresponding to the I/O addresses (S-LINK devices)
in the S-LINK.
3.1.2 Example of I/O Number and S-LINK Addresses
The illustration below shows an example of the relationship between the addresses in the S-LINK I/O
device and the addresses allocated to the S-LINK unit.
Contents of the illustration:
Control unit, S-LINK unit installed beside it.
I/O numbers allocated to the S-LINK unit are X100 to X11F (32 points) and Y100 to Y11F (32 points)
according to the I/O allocation of the FPΣ expansion unit.
Addresses on the S-LINK are input (0 to 31) and output (32 to 63).
Note:
• Setting contents selected with the I/O setting switch are read only the one time, when the power supply
to the FPΣ is turned on.
• For detailed information pertaining to the S-LINK, refer to the "S-LINK Design Manual".
3-2