Table Of Contents - JUKI MEB-3200 Instruction Manual

1. SPECIFICATIONS ...............................1
2. NAME OF EACH COMPONENT .........2
(1) Names of the sewing machine main unit ...2
3. INSTALLATION ..................................3
(1) Installing the air hose ................................3
(2) Raising and returning the sewing machine ....3
(3) Installing the thread stand.........................5
(4) Installing the operation panel base ..........5
(5) Installing/removing the presser unit ........6
(6) Attaching the dust bag ..............................6
4. PREPARATION BEFORE OPERATION ... 7
(1) Lubricating the machine and
how to lubricate ..........................................7
(2) Attaching the needle ..................................9
(3) Threading the machine head ..................10
(4) How to set the cloth ................................12
5. STRUCTURE OF THE
OPERATION SWITCH .......................13
(1) Structure of the operation panel .............13
(2) Temporary stop switch ............................15
(3) Hand switch ..............................................15
(4) Foot switch ...............................................15
6. HOW TO USE THE
OPERATION PANEL .........................16
(1) Basic operation of the sewing machine ....16
(2) Setting the thread tension .......................16
(3) Temporarily stopping the
sewing machine .......................................17
(4) Performing re-sewing ..............................17
(5) Performing threading ...............................18
(6) How to use the counter............................18
(7) When dropping of the knife is
temporarily not desired ..........................19
(8) Changing the operation mode ................19
(9) Changing procedure of the
sewing pattern ..........................................20
(10) Confirming the pattern shape .................20
7. SETTING PROCEDURE OF THE
SEWING DATA ..................................21
(1) Setting the knife No..................................22
(2) Setting the cut length...............................22
CONTENTS
(3) Setting the cut-before/cut-after knives...22
(4) Setting the number of stitches
of the parallel section .............................23
(5) Setting the number of stitches
of the eyelet ..............................................23
(6) Setting the cut space ...............................23
(7) Setting the eyelet space ..........................23
(8) Setting the length of taper bar ...............24
(9) Setting the number of stitches
of taper bar ...............................................24
(10) Setting the offset of taper bar .................24
(11) Setting the sewing speed ........................24
(12) Setting the reduction speed of eyelet ....25
(13) Setting the FUNCTION F1 ........................25
(14) Setting the FUNCTION F2 ........................25
8. ADJUSTMENT OF EACH PART .......26
(1) Replacing the cloth cutting knife
and the knife holder .................................26
(2) Adjusting the
cloth cutting knife pressure ....................27
(3) Worn-out of the knife holder face ...........28
(4) Setting the material thickness of the
cloth cutting knife ....................................28
(5) Adjusting the stitch bite width ................29
(6) Adjusting the presser ..............................29
(7) Adjusting the presser opening amount ...30
(8) Adjusting the feeding amount of the
needle thread ............................................31
(9) Adjusting the
thread take-up thread guide ....................31
(10) Adjusting the remaining amount of the
gimp (J and C types) ................................32
(11) Adjusting the gimp thread tension
(J and C types) .........................................32
9. COMPENSATION OF THE DATA .....33
(1) Knife position compensation ..................33
(2) Number of stitches of
sewing end compensation ......................33
(3) Compensation of turning.........................34
(4) Parallel section turning compensation ....34
(5) Eyelet crosswise compensation .............34
(6) Eyelet lengthwise compensation ............34
(7) Left eyelet lengthwise compensation ....34
x