Table of Contents
Advertisement
3-6. Installation of the table stand
(1) Install the table stand (No.1) which included in accessory box for prevent the table deflection.
(2) Place the table stand (No.1) at arbitrary position of the both end of machine table. Turn the adjust pad
(No.3) in the direction of arrow in below figure and adjust the stand height up to lightly contact with
bottom surface of the table. After adjustment tighten the lock nut (No.4).
NOTICE After finish the preceding work [3-5. Installation of the rubber cushion] install the table stand
(No.1).
<1>
<1>
<1>: Table stand <2>: Machine table <3>: Adjust pad <4>: Lock nut
<2>
<2>
<3>
<4>
View from table bottom
<1>
- 6 -
Advertisement
Table of Contents
