Installing The Thread Stand; Installing The Operation Panel Base - JUKI MEB-3200 Instruction Manual

(3) Installing the thread stand

(4) Installing the operation panel base

5) The sewing machine stops once more at the
final stage of lowering for the safety. Support the
periphery ribs of machine bed with your left hand,
hold the grip of hinge stopper section with your
right hand to release the lock and slowly lower the
sewing machine following the description of step 3).
DANGER :
Take care to prevent pinching of hands and
fingers between the sewing machine and the
bottom cover. In particular, never lower the
sewing machine holding parts other than
the bed rib with two or more workers, since
doing so can cause pinching of hands,
fingers and arms leading to a serious injury.
1) Assemble thread stand unit
2) Insert it in the hole located in the rear of the
machine table, and tighten locknut
thread stand.
When the ceiling wiring is possible, pass
the power cord through the spool rest rod.
Fix operation panel base
section on the machine table with wood screw
Protection vinyl is coated on the surface of
the operation panel. Remove it.
.
to fix the
at the dotting punch
.
5