Omron NJ Series Troubleshooting Manual page 95

Event code Event name
54015463 hex Motion Control
Instruction Re-exe-
cution Disabled
(SlaveOffset)
54015464 hex Motion Control
Instruction Re-exe-
cution Disabled
(SlaveScaling)
54015465 hex Motion Control
Instruction Re-exe-
cution Disabled
(StartPosition)
54015466 hex Instruction Execu-
tion Error with
Undefined Home
54015467 hex Motion Control
Instruction Re-exe-
cution Disabled
(Position Type)
54015468 hex Unused Axis Spec-
ification for Master
Axis
54015469 hex First Position Set-
ting Out of Range
5401546A hex Last Position Set-
ting Out of Range
5401546B hex Illegal First/Last
Position Size Rela-
tionship (Linear
Mode)
NJ-series Troubleshooting Manual (W503)
Meaning
An attempt was made to • A parameter for an
change the SlaveOffset
input variable when re-exe-
cuting a motion control
instruction. (This input vari-
able cannot be changed
when re-executing an
instruction.)
An attempt was made to • A parameter for an
change the SlaveScaling
input variable when re-exe-
cuting a motion control
instruction. (This input vari-
able cannot be changed
when re-executing an
instruction.)
An attempt was made to • A parameter for an
change the StartPosition
input variable when re-exe-
cuting a motion control
instruction. (This input vari-
able cannot be changed
when re-executing an
instruction.)
High-speed homing or an • High-speed homing
interpolation instruction
was executed when home
was undefined.
• An interpolation
An attempt was made to • A parameter for an
change the ReferenceType
input variable when re-exe-
cuting a motion control
instruction. (This input vari-
able cannot be changed
when re-executing an
instruction.)
The master axis specified • The master axis speci-
for a motion control instruc-
tion is an unused axis.
The parameter specified for • Instruction input
the FirstPosition input vari-
able to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the LastPosition input vari-
able to a motion control
instruction is out of range.
The parameter specified for • The value of the Last-
the LastPosition input vari-
able to a motion control
instruction is smaller than
the parameter specified for
the FirstPosition input vari-
able.
Assumed cause
Maj Prt
input variable that can-
not be changed for re-
execution was
changed.
input variable that can-
not be changed for re-
execution was
changed.
input variable that can-
not be changed for re-
execution was
changed.
was executed when
home was undefined.
instruction was exe-
cuted for an axes
group that includes an
axis with no defined
home.
input variable that can-
not be changed for re-
execution was
changed.
fied for a motion con-
trol instruction is an
unused axis.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
Position input parame-
ter is less than the
value of the FirstPosi-
tion input variable for
the instruction when
the Count Mode is set
to Linear Mode.
3 Error Tables
Level
Refer-
ence
Min Obs Info
S NJ-series
Instruc-
tions Ref-
erence
Manual
(Cat. No.
W502)
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
3-33
3