Omron NJ Series Troubleshooting Manual page 125

Event code Event name
54830000 hex Master Dis-
tance in
Acceleration
Specification
Out of Range
54840000 hex Master Dis-
tance in
Deceleration
Specification
Out of Range
54870000 hex Execution
Mode Selec-
tion Out of
Range
54880000 hex Permitted
Following
Error Out of
Range
54890000 hex Border
Point/Center
Posi-
tion/Radius
Specification
Out of Range
548A0000 hex End Point
Specification
Out of Range
548B0000 hex Slave Travel
Distance
Specification
Out of Range
548C0000 hex Phase Shift
Amount Out
of Range
548D0000 hex Feeding Dis-
tance Out of
Range
NJ-series Troubleshooting Manual (W503)
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterDistance- input variable.
ACC input variable
to a motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterDistan- input variable.
ceDEC input vari-
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ExecutionMode input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
PermittedDeviation input variable.
input variable to a
motion control
instruction is out of
range.
The parameter
• The value of AutPoint exceeded
specified for the signed 40-bit data when con-
AuxPoint input vari- verted to pulses for the border
able to a motion point or center specification
control instruction is method.
out of range.
• For a radius specifications, the
absolute value of AuxPoint[0]
exceeded 40-bit data when
converted to pulses.
The parameter • The instruction input parameter
specified for the exceeded the range of signed
EndPoint input vari- 40-bit data when it is converted
able to a motion to pulses.
control instruction is
out of range.
The parameter • The instruction input parameter
specified for the exceeded the range of 40-bit
SlaveDistance input data when it is converted to
variable to a motion pulses.
control instruction is
out of range.
The parameter • The absolute value of the
specified for the instruction input parameter
PhaseShift input exceeded the range of 40-bit
variable to a motion data when it is converted to
control instruction is pulses.
out of range.
The parameter • The absolute value of the
specified for the instruction input parameter
FeedDistance input exceeded the range of 40-bit
variable to a motion data when it is converted to
control instruction is pulses.
out of range.
3 Error Tables
Level
Maj Prt Min Obs Info
S NJ-series
Motion Con-
trol Instruc-
tions
Reference
Manual (Cat.
No. W508)
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
Reference
3
3-63