Omron NJ Series Troubleshooting Manual page 120

3 Error Tables
Event code Event name
545C 0000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(MasterStart-
Distance)
545D 0000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(Continuous)
545E0000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(MoveMode)
545F 0000 hex Illegal Auxil-
iary Axis
Specification
54600000 hex Illegal Axis
Specification
54610000 hex Illegal Axes
Group Speci-
fication
54620000 hex Illegal Mas-
ter Axis
Specification
3-58
Meaning Assumed cause
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
MasterStartDis-
tance input variable
when re-executing
a motion control
instruction. (This
input variable can-
not be changed
when re-executing
an instruction.)
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
Continuous input
variable when re-
executing a motion
control instruction.
(This input variable
cannot be changed
when re-executing
an instruction.)
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
MoveMode input
variable when re-
executing a motion
control instruction.
(This input variable
cannot be changed
when re-executing
an instruction.)
The axis specified • An axis does not exist for the
for the Auxiliary variable specified for the Auxil-
input variable to a iary input variable to the
motion control instruction.
instruction does not
exist.
The axis specified • An axis does not exist for the
for the Axis input variable specified for the Axis
variable to a motion input variable to the instruction.
control instruction
does not exist.
The axes group • An axes group does not exist
specified for the for the variable specified for the
AxesGroup input AxesGroup input variable to the
variable to a motion instruction.
control instruction
• The axes group specified for
does not exist or is
the AxesGroup input variable to
not a used group.
the instruction is not specified
as a used group.
The axis specified • An axis does not exist for the
for the Master input variable specified for the Master
variable to a motion input variable to the instruction.
control instruction
• The axis that was specified for
does not exist or is
the Master input variable to the
not a sync master
MC_Phasing (Shift Master Axis
axis.
Phase) instruction is not the
master axis for syncing.
Level
Maj Prt Min Obs Info
S NJ-series
Motion Con-
trol Instruc-
tions
Reference
Manual (Cat.
No. W508)
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
NJ-series Troubleshooting Manual (W503)
Reference