Omron NJ Series Troubleshooting Manual page 126

3 Error Tables
Event code Event name
548E 0000 hex Auxiliary and
Slave
Defined as
Same Axis
548F 0000 hex Relative
Position
Selection Out
of Range
54900000 hex Cam Transi-
tion Specifi-
cation Out of
Range
54910000 hex Synchro-
nized Con-
trol End
Mode Selec-
tion Out of
Range
54920000 hex Enable Exter-
nal Latch
Instruction
Execution
Disabled
54930000 hex Master Axis
Offset Out of
Range
54940000 hex Slave Axis
Offset Out of
Range
54950000 hex Command
Current Posi-
tion Count
Selection Out
of Range
54960000 hex Master Axis
Gear Ratio
Numerator
Out of Range
3-64
Meaning Assumed cause
The same axis was • The parameter is the same for
specified for the the Auxiliary and Slave input
Auxiliary and Slave variables to the instruction.
input variables to a
motion control
instruction.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Relative input vari- input variable.
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
CamTransition input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
OutMode input vari- input variable.
able to a motion
control instruction is
out of range.
_mcImmediateStop • _mcImmediateStop was speci-
was specified for fied for the StopMode input
the StopMode input variable when the
variable when the MC_TouchProbe (Enable Exter-
MC_TouchProbe nal Latch) instruction was exe-
(Enable External cuted in Drive Mode, but the
Latch) instruction Control Mode was not CSP
was executed in Mode or the Servo was OFF.
Drive Mode, but the
Control Mode was
not CSP Mode.
The parameter • The instruction input parameter
specified for the exceeded the range of signed
MasterOffset input 40-bit data when it is converted
variable to a motion to pulses.
control instruction is
out of range.
The parameter • The instruction input parameter
specified for the exceeded the range of signed
SlaveOffset input 40-bit data when it is converted
variable to a motion to pulses.
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
CmdPosMode input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
RatioNumerator- input variable.
Master input vari-
able to a motion
control instruction is
out of range.
Level
Maj Prt Min Obs Info
S NJ-series
Motion Con-
trol Instruc-
tions
Reference
Manual (Cat.
No. W508)
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
S Same as
above.
NJ-series Troubleshooting Manual (W503)
Reference