Cleveland SteamCraft 10 Service Manual page 71

Models 24-CGA-10, 24CGP-10, 24-CEA-10, 24-CEP-10
Figure 4-1 - Steam Generator Cover Plate
Electric Atmospheric Model 24-CEA-10
Cleveland Range, Inc.
SteamCraft 10 Service Manual, Chapter 4
The liquid phosphoric acid in descaling kit 104394 can
be harmful it not handled properly. Follow these basic
safety rules for handling and using acid.
Wear protective clothing when mixing or applying
chemical cleaners. Wear rubber gloves, mask and
approved cup-type goggles.
Avoid breathing fumes. If liquid comes in contact with
skin, flush immediately with large quantities of cold
water. Remove contaminated clothing.
If chemical contacts eyes, flush with cold water for a
minimum of 15 minutes. Get immediate medical
attention.
If chemical is swallowed or ingested, follow in-
structions on the chemical container. Get imme diate
medical attention.
Do not use powdered sulphoric acid, part number
101751. This material will damage the float assembly
and other SteamCraft 10 components.
Do not scrape heating elements with a solid tool.
If the steamer is turned OFF, energize the steamer by pressing the ON/OFF
switch to ON. Allow time for the steam generator to fill (3 to 4 minutes).
This assures that blowdown occurs.
1. Press the ON/OFF switch to OFF.
2. Press the TIMED/MANUAL switch to TIMED. Set timer to 0.
3. After completion of blowdown (3 minutes), turn off power at the main
disconnect switch.
4. Allow time for the steam generator and compartment to cool down.
5. Access steam generator descaling port.
• Electric Atmospheric Model (24-CEA-10):
a. Remove right side access panel (see Figure 2-7).
b. Remove the 3x3 inch cover plate. See Figure 4-1.
• Electric Pressure and All Gas Models (24-CEP-10, 24-CGA-10. and 24-
CGP-10):
a. On gas models, loosen mounting screws of exhaust vent and remove
exhaust vent.
WARNING
CAUTION
Page 65
Printed 3/93