Cleveland SteamCraft 10 Service Manual page 61

Page 54 Chapter 3, SteamCraft 10 Service Manual
Figure 3-5. Door Gasket Assembly
Models 24-CGA-10, 24-CGP-10, 24-CEA-10, 24-CEP-10
abrasive cleaning compounds or steel wool. Rinse inside of steamer
compartment with clean water.
Let rinse water drain through compartment drain
opening. If water does not drain freely, drain lines
must be cleaned before cooking again. Clogged or
slow drains are dangerous because hot water can
collect in compartment and spill out when opening
compartment door.
5. Clean the door assembly.
• Remove the door gasket assembly (see Figure 3-5).
• Note the keyhole slots on the door and the retaining pins on the gasket
assembly. Grasp the gasket assembly at the sides and lift up and towards
you to remove the assembly.
• Clean all surfaces of the gasket assembly, as well as the inside of the
door, by wiping with a damp cloth.
• Replace the gasket assembly by sliding the retaining pins into the
keyhole slots. Either long edge of the gasket assembly can be positioned
at the top.
6. Replace the cleaned slide racks.
7. Wipe the exterior with a damp cloth only. NEVER HOSE DOWN THE
STEAMER. Electrical components inside the unit will not function
correctly if wet or damp.
8. After cleaning, leave the steamer door open until the next steamer
operation. This prevents compartment odor buildup and increases gasket
life.
WARNING