Mercedes-Benz COMAND Operator's Manual page 76

No stopover destination available yet
Select a category.
A stopover destination exists
Change Stopover
To change: Select
Select a category.
Select another stopover destination
Selecting a predefined category
COMAND first searches for destinations
along the route within the selected catego-
ry. COMAND then searches for destina-
tions in the vicinity of the vehicle's
location.
If COMAND is unable to find any destina-
tions, a message to that effect will be dis-
played.
OK
Select .
If necessary, select another category.
If COMAND finds destinations, a list is
displayed in the right-hand part of the
screen.
Here you will find the stopover destina-
tions in the selected category, sorted
by increasing distance from the current
vehicle location.
The list shows:
.
Name
Information on the location of the
stopover destination in relation to
the direction of travel and the
Current distance to the stopover
destination.
To choose a destination: Press %
or $.
To select a destination: Press C.
The Enter Destination menu appears
and displays the address of the desti-
nation.
To cancel selection: Select
To start route calculation: Select
Start
, see also ( page 70).
Entering another Destination as Stop-
over Destination
If necessary switch to navigation mode
and display menu system ( page 53).
Destination
Select
To enter: Select
Choose from:
Address Entry
From Memory
From Last Destinations
From POIs
Select a menu item.
The rest of the destination entry will vary
depending on the selection made:
Address Entry
For the
Entering a Destination via the Address
Back
.
( page 62).
From Memory
For the
Entering a Destination from the Desti-
nation Memory ( page 71).
Navigation
Destination Input
Stopover
.
£
OTHER
.
option see:
option see:
75