Mercedes-Benz COMAND Operator's Manual page 192

Remote Control
1 Switching the display screen on or off
2 Switching on/off the key illumination
3 Selecting the display screen (left/right)
4 Selecting menu item or menu (arrows)
5 Confirming selection (OK)
6 Muting the playback
7 Setting the Volume (wired headset)
8 Skipping tracks forward/backward
9 Selecting a title directly
a Leaving a menu
Selecting the Active Display Screen for
the Remote Control
With the remote control you can select
which of the two display screens is respon-
sive to the remote control.
Selecting the left/right display
screen: Rotate the wheel 3 until L or
R appears in the small window.
Switching On/Off the Display Screen
i
If the ignition key is in position 0 or 1
( vehicle operating guide) or the key is not in-
serted, the display screens are switched off au-
tomatically after 30 minutes. Before switching
off a corresponding message appears.
You can switch on the screen(s) again but be
aware it will continue to discharge the vehicle
battery.
Rear Seat Entertainment System
General Information
Point the remote control to the active
screen and press the button On/Off 1
on the remote control
The display screen is switched on or
off.
i
Switching on with the remote control is only
possible if the ignition is on.
Muting the Audio Playback (Only Wired
Headset)
Press the button 6 on the remote con-
.
trol
Depending on the previous state the
sound is switched on or off.
Selecting a Menu Item and Confirming
the Selection
Selecting the menu item: Press the
arrow buttons 4 on the remote con-
.
trol
Confirming the selection: Press the
OK button 5.
.
191