Mercedes-Benz COMAND Operator's Manual page 59

Navigation
Introduction
The map display appears with the block
area marked red.
Press Ì or Í until the desired
size of the block area is set.
Press %, $, ( or & to
shift the block area to the desired re-
gion.
To confirm the area and exit map
display: Press C.
Hide menu system if applicable
( page 53).
Defining a New Block Area
Avoid New Area
Select .
The map display appears with a default
new block area in red.
Press Ì or Í until the desired
size of the new block area is set.
Press % or $, ( or & to
shift the new block area to the desired
region.
To confirm the area and exit map
display: Press C.
Hide menu system if applicable
( page 53).
58
Deleting a Block Area
To select the area you want to de-
lete: Press % or $.
Options Delete
£
Select .
You will be prompted to confirm that
you wish to delete the block area.
Yes No
Select or .
Yes
If you select COMAND deletes the
entry. A message will be displayed.
Saving a Off-road Route
If this function is switched on, an Off-road
route is recorded and stored.
Switching the Function On/Off
Show the menu system, if necessary
( page 53).
Navi Save Off-road Route
£
Select
Save Off-road Route
Select
menu.
Depending on the previous state,
switch the option on Ç or off c.
Displaying Memory Usage
i
When the memory is 90% full, you see a
message to this effect. When the memory is full,
the function is no longer available and a message
appears.
To confirm the message:
Press the C button.
i
In order to be able to continue using the
.
"Record route" function, you should delete the
in the sub-
route memory afterwards.
Show the menu system, if necessary
( page 53).
Navi
Select
road Route Memory
Save Off-road Route Off-
£ £
.