Teledyne D series Installation And Operation Manual page 178

D Series Syringe Pumps
Section 8 Serial Interface
Command
PRESSCNTRLDIFF1
PRESSCNTRLDIFF1=XXXXX
PRESSCNTRLDIFF2
PRESSCNTRLDIFF3
PRESSCNTRLNORM
PRESSDIFF=XXXXX
PRESSDIFF
RANGEA
RANGEB
RANGEC
RANGED
RAPIDA
RAPIDB
RAPIDC
RAPIDD
RECEIVE
RECEIVECD
REFILL
REFILLB
REFILLC
REFILLD
REFILL=#
REFILLB=#
REFILLC=#
REFILLD=#
REMOTE
RLIMITA
RLIMITB
RLIMITC
RLIMITD
RSVP
RSVPB
RSVPC
RSVPD
RUN
RUNB
RUNC
RUND
RUNALL
SETFLOWA
SETFLOWB
SETFLOWC
SETFLOWD
8-24
Table 8-6 Serial Commands (Continued)
Description
Sets the pressure control input to Analog input 1, with a pressure range of 50 psi.
Sets the pressure control input to Analog input 1 and sets the pressure range. The
range is 1 to 5000. the units are psi, with a value of 5000 representing 5000 psi at 5
volts.
Sets the pressure control input to Analog input 2, with a pressure range of 500 psi at
5 volts.
Sets the pressure control input to Analog input 2, with a pressure range of 5000 psi
at 5 volts.
Sets the pressure control input to the standard input.
Differential pressure setpoint. (PSI*10) 0 to 50,000 maximum (0 to 5000 psi)
Reads the differential pressure value. (PSI*10) The transducer can also be read via
the "ALOGx" serial commands.
Provides scaling information for the system parameters. See 8.8.4 for more informa-
tion about this serial command.
Activates the automatic rapid pressurization cycle (constant flow mode only).
Set the dual pump mode to receive fluid when running.
Move cylinder to bottom at preset refill rate.
Enter # to designate refill rate.
Disables controller front panel control and enables all serial commands. Stops all
motors (if control was previously local).
Returns the refill flow rate limit.
Pump responds with "READY" message.
Same as front panel. Initiates pumping.
Returns the flow rate setpoint.