Teledyne D series Installation And Operation Manual page 177

Command
MAXPRESSA
MAXPRESSB
MAXPRESSC
MAXPRESSD
MFLOWA=#
MFLOWB=#
MFLOWC=#
MFLOWD=#
MFLOWA
MFLOWB
MFLOWC
MFLOWD
MINFLOWA=#
MINFLOWB=#
MINFLOWC=#
MINFLOWD=#
MINFLOWA
MINFLOWB
MINFLOWC
MINFLOWD
MINPRESSA=#
MINPRESSB=#
MINPRESSC=#
MINPRESSD=#
MINPRESSA
MINPRESSB
MINPRESSC
MINPRESSD
MODE
MODIFIER
PRESS=#
PRESSB=#
PRESSC=#
PRESSD=#
PRESS
PRESSCD
PRESSA
PRESSB
PRESSC
PRESSD
Table 8-6 Serial Commands (Continued)
Description
Returns the maximum pressure setpoint.
Enter # to designate the maximum flow limit in constant pressure mode.
Returns the maximum flow limit setpoint.
Enter # to designate the minimum flow rate setpoint.
Returns the minimum flow rate setpoint.
Returns the minimum pressure setpoint.
Returns the minimum pressure setpoint.
MODE A P, B P, C P, D-P
A, B, C, D refer to the pump connection.
P- Constance Pressure
F- Constant Flow
R- Refill
PG- Pressure Gradient
F1- Flow Gradient 1 Pump
F2- Concentrated Gradient 2 Pump
CF- Continuous Constant Flow
CP- Continuous Constant Pressure
MO- Modifier Mode 2 Pump
MM- Modifier Mode 3 Pump
Put pumps in modifier addition mode.
Enter # to designate pressure setpoint (constant pressure mode).
Returns the delivering pump pressure in continuous pumping mode and modifier
addition mode. In INDEPENDENT mode PRESS returns the pump A pressure and
PRESSCD returns the pump C pressure.
Returns the actual pressure of the pump.
D Series Syringe Pumps
Section 8 Serial Interface
8-23