Serial Commands For The D Series Pump; Serial Commands - Teledyne D series Installation And Operation Manual

D Series Syringe Pumps
Section 8 Serial Interface
8.8 Serial Commands for
the D Series Pump
Command
%B=#
ALOG1
ALOG2
ALOG3
ALOG4
ALOG5
ALOG6
CLEAR
CONTIN CONST FLOW
CONTIN CONST FLOWCD
CONTIN CONST PRESS
CONTIN CONST PRESSCD
CONTIN MODIFIER
CONST FLOW
CONST FLOWB
CONST FLOWC
CONST FLOWD
CONST PRESS
CONST PRESSB
CONST PRESSC
CONST PRESSD
DELIVER
DELIVERCD
DIGITAL
DIGITAL = xxxxxxxx
1
8
8-20
Table 8-6 is a list of the serial commands recognized by the
pump. These commands are the message part of the DASNET
protocol. The operand always follows the equals sign. The
REMOTE command must be sent once, before any command that
changes the operation of the pump will be accepted.
Note
When setting a value, the serial command will always be fol-
lowed by an equal sign.
Table 8-6 Serial Commands
Description
Enter # for percentage of modifier.
Status of the analog voltage input on pin 21, P6. See NOTE 1.
Status of the analog voltage input on analog input 3 of the accessory connector. See
NOTE 1.
Status of the analog voltage input on analog input 2 of the accessory connector.
See NOTE 1.
Status of the analog voltage on analog input 1 of the accessory connector.
See NOTE 1.
Status of the analog voltage input for Press D. See NOTE 1.
Status of the analog voltage on analog input 4 of the accessory connector.
See NOTE 1.
Stops all motors, sets flow rate and pressure setpoints to zero.
Puts pump in continuous flow under constant flow mode.
Puts pump in continuous flow under constant pressure mode.
Put pump in continuous modifier addition mode.
Put pump in constant flow mode.
Put pump in constant pressure mode.
Set the dual pump mode to deliver fluid when running.
Returns the status (High or Low) of the digital outputs. Format is digital = xxxxxxxx,
where "x" is either "H" or "L". The status order returned corresponds with the outputs
1—8. "X"= no change.
Sets the digital output either High or Low, where "x" is either "H" or "L". The order cor-
responds with the outputs 1—8.