Table of Contents
Advertisement
Installing and configuring SSH for SOL
Complete the following steps to install and configure Secure Shell Server (SSH) for SOL:
SBCE management-module Web interface (see
1.
Start the
Web interface" on page 3).
2.
If you have not previously installed the SSH security key file, complete the following steps:
a.
Download the security key from http://downloadfinder.intel.com, type "SSL" in the Download Search
box and click on "Go!". Or, you may contact your Intel Corporation Support Representative.
b.
Scan the search results list and click on "Intel
c.
Under "select your operating system", select "OS Independent" from the drop-down menu and click
"Go!".
d.
Click on the "Intel
[SSL_INSTALL.EXE]" and follow the online instructions to download the SSL key.
e.
You should receive a response from the Encryption Coordinator within two business days, containing
a link to the file and password. Using this information, download and save the file.
f.
Run the executable to extract the hex file.
g.
After saving and extracting the SSL key file, browse to the SSL_install.hex key file in the MM
Security screen and click on "Install SSL".
h.
After you load the key, the Security choices are now enabled.
3.
Complete the following steps to enable SSH:
a.
Scroll to the
Enabled for the SSH Server
b.
Select
OK
c.
Click
to confirm.
4.
Complete the following steps to restart the management module. Restarting the management module ends
the current SBCE management-module Web interface session.
a.
In the navigation pane, click
Restart
b.
Click
OK
c.
Click
to confirm.
Yes
d.
Click
to restart the management module and end the session.
You can now use an SSH client to start a secure Telnet session with the management module and secure SOL
sessions with the blade servers.
Completing the SOL configuration
Complete the following steps to complete the SOL configuration for your SBCE unit:
1.
Make sure that the global SOL parameters are correct for your SBCE
status" on page 4).
2.
Make sure that the SOL settings for individual
"Component-specific configuration," on page 17).
SBCE management-module Web interface (see
3.
Start the
Web interface" on page 3).
Complete the following steps to enable SOL on the blade servers:
4.
a.
In the navigation pane, click
LAN Status
b.
Select each blade server that will have SOL enabled; then click
14
®
Server Management Module SBCECMM SSL Installation Key
Secure Shell (SSH) Server
option; then, click
MM Control
.
Blade Tasks
section.
"Starting the SBCE management-module
®
Blade Server Chassis SBCE".
section.
Save
.
Restart MM
-->
.
unit (see
SBCE components are correct (see
"Starting the SBCE management-module
Serial Over LAN; then, scroll to the Serial Over
-->
Enable Serial Over LAN.
Intel® Blade Server Chassis SBCE: Serial over LAN (SOL) Setup Guide
"Global SOL settings and
Chapter 3,
Advertisement
Table of Contents
