Table of Contents
Advertisement
Microsoft Windows 2003 Advanced Edition configuration
This procedure is based on a default installation of the Microsoft* Windows* 2003 operating system.
Complete the following steps to configure the Windows* 2003 operating system for SOL operation. You must
be logged in as a user with administrator access to perform this procedure.
1.
Complete the following steps to determine which boot entry ID to modify:
bootcfg at a
a.
Type
options for your system.
Boot Entries
b.
In the
Windows Server 2003, Standard. Write down the boot entry ID for use in the next step.
Microsoft
2.
To enable the
command prompt, type
bootcfg /EMS ON /PORT COM2 /BAUD 19200 /ID boot_id
where boot_id is the boot entry ID determined from step 1
3.
Complete the following steps to verify that the EMS console is redirected to the COM2 serial port:
bootcfg at a Windows
a.
Type
options for your system.
b.
Verify the following changes to the bootcfg settings:
Boot Loader Settings section, make sure that redirect is set to COM2 and that
•
In the
redirectbaudrate is set to 19200
Boot Entries section, make sure that the
•
In the
/redirect appended to the end of it.
The following samples show examples of the original bootcfg program output and the output after
modification.
Boot Loader Settings
----------------------------
timeout: 30
default: multi(0)disk(0)rdisk(0)partition(1)\WINDOWS
Boot Entries
----------------
Boot entry ID: 1
OS Friendly Name: Windows Server 2003, Standard
Path: multi(0)disk(0)rdisk(0)partition(1)\WINDOWS
OS Load Options: /fastdetect
12
Windows command prompt; then press Enter to display the current boot
section, locate the boot entry ID for the section with an OS friendly name of
®
Windows Emergency Management System (EMS), at a Windows
command prompt; then, press Enter to display the current boot
.
Original bootcfg program output
Intel® Blade Server Chassis SBCE: Serial over LAN (SOL) Setup Guide
; then, press Enter.
line has
OS Load Options:
Advertisement
Table of Contents
