Table of Contents
Advertisement
#grub.conf generated by anaconda
#
# Note that you do not have to rerun grub after making changes to this file
# NOTICE:
You have a /boot partition.
#
all kernel and initrd paths are relative to /boot/, eg.
#
root (hd0,0)
#
kernel /vmlinuz-version ro root=/dev/hda6
#
initrd /initrd-version.img
#boot=/dev/hda
default=0
timeout=10
# splashimage=(hd0,0)/grub/splash.xpm.gz
# This will allow you to only Monitor the OS boot via SOL
title Red Hat Enterprise Linux ES (2.4.9-e.12smp) SOL Monitor
root (hd0,0)
kernel /vmlinuz-2.4.9-e.12smp ro root=/dev/hda6 console=ttyS1,19200
console=tty1
initrd /initrd-2.4.9-e.12smp.img
# This will allow you to Interact with the OS boot via SOL
title Red Hat Linux (2.4.9-e.12smp) SOL Interactive
root (hd0,0)
kernel /vmlinuz-2.4.9-e.12smp ro root=/dev/hda6 console=tty1
console=ttyS1,19200
initrd /initrd-2.4.9-e.12smp.img
title Red Hat Enterprise Linux ES-up (2.4.9-e.12)
root (hd0,0)
kernel /vmlinuz-2.4.9-e.12 ro root=/dev/hda6
initrd /initrd-2.4.9-e.12.img
You must reboot the Linux operating system after completing these procedures for the changes to take effect
and to enable SOL. For some blade servers, you must also install device drivers for your Ethernet controller:
•
If you are using a Intel
Gigabit Ethernet Controller Device Driver for Linux Operating Systems. See "Installing the Broadcom
NetXtreme Gigabit Ethernet controller device driver" on page 22 for instructions.
•
If you are using a Intel
Controller Device Driver for Linux Operating Systems.
device driver" on page 23 for instructions.
Modified /boot/grub/grub.conf contents
®
Server Compute Blade SBXL52, you must also install the Broadcom* NetXtreme
®
Server Compute Blade SBX44
This means that
,
you must also install the Intel
See
"Installing the Intel
™
Ethernet
®
Ethernet controller
11
Advertisement
Table of Contents
