Server Compute Blade Sbxl52; Sol Jumper Placement - Intel SBCE Setup Manual

3) Set the values in the
listed in the
IP address: x.x.x.x
•
Subnet mask: x.x.x.x
•
Gateway address: x.x.x.x
•
The static IP configuration values specify valid IP addresses of the form x.x.x.x, where each x is a
number from 0 to 255.
If you changed any values, click Save.
c. Complete the following steps to configure the Serial over LAN settings
1) In the navigation pane, click
2) Scroll to the
• Set the
• Set the
the SBCE unit. Valid IP addresses are of the form x.x.x.x, where each
255.
Accumulate timeout
•
Send threshold
•
Retry count
•
Retry interval
•
Save
3) Click
Do not attempt to enable or disable SOL on any of the blade servers that are listed in the Serial Over
LAN Status section.
5. Complete the following steps to restart the management module. Restarting the management module ends
the current SBCE management-module Web interface session
a. In the navigation pane, click
Restart
b. Click
OK
c. Click to confirm.
Yes
d. Click to restart the management module and end the session.
Configuring the Intel
If an SOL session for the Intel
screen, this indicates an interruption in the flow of serial data. Press Ctrl+q to resume serial data flow.
The following sections describe the SOL configuration that is required for the Intel
SBXL52. You must perform the following procedures:
• "SOL jumper placement" on page 19
• "Updating and configuring the BIOS" on page 20
• "Updating the integrated systems management processor firmware" on page 21
• "Updating the Broadcom* NetXtreme* Gigabit Ethernet controller firmware" on page 22
• "Installing the Broadcom NetXtreme Gigabit Ethernet controller device driver" on page 22

SOL jumper placement

For SOL operation, jumper J28 on the blade server must be installed on pins 2 and 3. This is the default jumper
position that directs SOL data to I/O-module bay 1 in the SBCE unit.
New Static IP Configuration
Current IP Configuration
Blade Tasks
Serial Over LAN Configuration
Serial Over LAN
field to
BSMP IP address range
field should be set to 5.
field should be set to 100.
field should be set to 3.
field should be set to 250.
.
MM Control
.
®

Server Compute Blade SBXL52

®
Server Compute Blade SBXL52 displays only a flashing cursor in a blank
fields, if they are not already correct as
section. The values must be in the following formats:
:
Serial Over LAN
-->
section and set the values as follows
Enabled
.
field to the base IP address for blade servers installed in
.
Restart MM
--> .
.
:
x
is a number from 0 to
®
Server Compute Blade
19