Ending An Sol Session; Restarting A Blade Server Through Sol; Mounting And Unmounting Media For Linux Operating Systems - Intel SBCE Setup Manual

console -T system:blade[14]
NOTE
If an SOL session for the Intel
blank screen, this indicates an interruption in the flow of serial data. Press Ctrl+q to resume serial
data flow.

Ending an SOL session

To end an SOL session, press Esc followed by an open parenthesis:
Esc (
When the SOL session ends, the command-line interface returns to the persistent command target that was in
effect before the SOL session. If you want to end the Telnet or SSH command-line session, type exit.
NOTE
Exiting an SOL session does not stop the flow of serial data.

Restarting a blade server through SOL

You can restart a blade server during an SOL session by typing a specific key sequence. This makes it possible
to restart the blade server without ending the SOL session so that you can use the restart command in the
management-module command-line interface.
Type the following key sequence (Esc R Esc r Esc R) to restart a blade server during an SOL session:
1. Press Esc.
2. Type a capital R by pressing Shift and r at the same time.
3. Press Esc.
4. Press r.
5. Press Esc.
6. Type a capital R by pressing Shift and r at the same time.
The blade server that is hosting this SOL session restarts, returning to the SOL session that is already in
progress.
Mounting and unmounting media for Linux operating
systems
The following sections describe how to mount and unmount media using the Linux operating system for each
blade server type.
®
Server Compute Blade SBXL52 displays only a flashing cursor in a
27