Table of Contents
Advertisement
The SOL column of the table will show a status of Enabled for each of the blade servers that was
selected. The SOL Session column of the table indicates a status of Not Ready for each of the blade
servers that was selected.
To disable SOL for a blade server, complete step 4(a) and click Disable Serial Over LAN instead of
Enable Serial Over LAN.
The blade server SOL status periodically updates itself automatically; however, you can refresh the
window for an immediate display of updated status.
5.
Complete the following steps to power-on or restart the blade servers on which SOL was enabled:
a.
In the navigation pane, click
b.
Select each blade server on which SOL was enabled; then, click either
Restart Blade
, depending on the current status of the blade servers.
OK
c.
Click
twice to confirm.
Complete the following steps to check the SOL status of the blade servers:
6.
a.
In the navigation pane, click
LAN Status
section.
b.
Make sure that the
®
For the Intel
Server Compute Blade SBXL52, if the SOL Session column does not show a status of
Ready, make sure that the J28 jumper on the blade server is in the correct position. See "SOL jumper
placement" on page 19 for information.
Blade Tasks
-->
Blade Tasks
-->
SOL Session column of the table shows a status of Ready.
Power/Restart
.
Power On Blade or
Serial Over LAN; then, scroll to the Serial Over
15
Advertisement
Table of Contents
