Figure 34. Installing Hard Disk Drive - Removing 3.5" Hdd Interface Bracket; Figure 35. Installing Hard Disk Drive - Installing 3.5" Hdd; Figure 36. Installing Hard Disk Drive - Installing 2.5" Hdd - Intel R1000EP Series Service Manual

Figure 34. Installing Hard Disk Drive – Removing 3.5" HDD interface bracket
3. Install the hard disk drive using the same four screws as shown. Make sure the connector end of
the drive matches the backplane connector (see letter D).
For installing 2.5" Hard Disk Drive as option:
Break off the tab on the HDD interface bracket (see letter d1).Install the HDD interface bracket
from top. Secure the bracket with three screws as shown (see letter d2). Slide the 2.5" HDD into
the bracket to align the screw holes with the right and left rail (see letter d3). Secure the hard
disk drive using the four screws for 2.5" HDD (see letter d4).
4. With the lever open, insert the hard disk drive assembly into the chassis (see letter E). Push in
the lever to lock it into place (see letter F).
®
Intel Server System R1000EP Service Guide
Figure 35. Installing Hard Disk Drive – Installing 3.5" HDD
Figure 36. Installing Hard Disk Drive – Installing 2.5" HDD
Server System Features
25