Omron CS1W-AD041-V1 Operation Manual page 171

Exchanging Data with the CPU Unit
Set Values and Stored Values
I/O
Output Conversion enable
Set value
Output setting error
Common Alarm Flags
Allocation for Adjustment
Mode
I/O Word
15
Output n Not used.
(CPU to
Unit)
n + 1 Not used.
n + 2 Not used.
n + 3 Not used.
n + 4 Not used.
n + 5 Not used.
n + 6 Not used.
n + 7 Not used.
Input n + 8 Conversion value or set value at time of adjustment
(Unit to
16
CPU)
n + 9 Alarm Flags
Note
148
Item
0: Conversion output stopped.
1: Conversion output begun.
16-bit binary data
0: No error
1: Output setting error
Bits 00 to 03: Output set value error
Bits 04 to 09: Not used
Bit 10:
Bit 11:
Bit 15:
For adjustment mode, set the operation mode switch on the rear panel of the
Unit as shown in the following diagram. When the Unit is set for adjustment
mode, the ADJ indicator on the front panel of the Unit will flash.
The allocation of CIO words and bits is shown in the following table.
14 13 12 11
3 2
16
1. For the CIO word addresses, n = CIO 2000 + (unit number x 10).
2. The range is 1 to 4 for the CS1W-DA04.
Contents
Output hold setting error
Not used
Operating in adjustment mode
(always 0 in normal mode)
Bits
10 9 8 7 6
Outputs to be adjusted
2 (fixed)
Not used. Clr
1
16
Not used.
Section 4-5
Page
151
150
153
147, 164
5 4 3 2 1
1 to 8 (See note 2.)
Set Up Down Gain Off-
0
16
0
set