If A Paper Mismatch Occurs - Ricoh SP 330SN User Manual

• In the following setting menu, you can specify which paper tray is selected first when the trays are
automatically selected while you are printing. For details about [Paper Tray Priority], see
page 266 "Paper Settings (When Using the Touch Panel Model)" or page 304 "Tray Paper
Settings (When Using the Four-line LCD Panel Model)".
• When using the touch panel model: [Paper Tray Priority] under [Paper Settings]
• When using the four-line LCD panel model: [Paper Tray Priority] under [Tray Paper Settings]
• If a paper jam occurs, printing stops after the current page has been printed out. After the jammed
paper is removed, printing restarts from the jammed page automatically. For details about how to
remove the jammed paper, see page 404 "Removing Paper Jams".
• After printing on envelopes, make sure to pull up the levers for printing on envelopes back to their
original positions. Leaving the levers lowered can cause print quality problems when printing on
paper other than envelopes. For details about the levers for printing on envelopes, see page 56
"Loading Paper".

If a Paper Mismatch Occurs

The machine reports an error if:
• The paper size does not match the print job's settings when the following setting item is enabled.
• When using the touch panel model: [Size Mismatch Detection] under [Paper Settings]
• When using the four-line LCD panel model: [Size Mismatch Detection] under [Tray Paper
Settings]
• The paper type does not match the print job's settings when [Input Tray:] is set to [Auto Tray Select].
There are two ways to resolve these errors:
Continue printing using mismatched paper
Ignore the error and print using mismatched paper.
Cancel the print job
Cancel printing.
• For details about [Size Mismatch Detection], see page 266 "Paper Settings (When Using the
Touch Panel Model)" or page 304 "Tray Paper Settings (When Using the Four-line LCD Panel
Model)".
• If [Auto Continue] under [System Settings] is enabled, the machine ignores the paper type and size
settings and prints on whatever paper is loaded. Printing stops temporarily when the error is
detected, and restarts automatically after about ten seconds using the settings made on the control
panel. For details about [Auto Continue], see page 256 "System Settings (When Using the Touch
Panel Model)" or page 294 "System Settings (When Using the Four-line LCD Panel Model)".
Basic Operation of Printing
99