Ricoh SP 330SN User Manual page 250

7. Configuring the Machine Using the Control Panel
Item
Auto Reduction Sets the machine to reduce the size of
No. of Rings
(TAD)
Number of
Rings
RX Mode
Switch Time
Receive
Conditions
Duplex Print
248
Description
a received fax if it is too large to print
on a single sheet of paper.
Note that the machine only reduces
the size down to 74%. If further
reduction is required to fit the fax on a
single sheet, it will be printed on
separate sheets without being
reduced.
Specifies the number of times the
external telephone answering device
rings before the machine starts to
receive faxes in FAX/TAD mode.
Specifies the number of times the
machine rings before it starts to receive
faxes in Fax Only mode.
Specifies how long the machine rings
before it starts to receive faxes in FAX/
TEL(Auto) mode.
Specifies whether to receive or reject
faxes from the programmed Special
Senders.
Specify whether or not received fax
documents are to be printed on both
sides of the paper.
Value
• Off
• On
Default: [On]
Default may be [Off] depending on
the [Country] setting under
[Administrator Tools].
1 to 20 times, in increments of 1
Default: 5 times
3 to 5 times
Default: 3 times
5 to 99 seconds
Default: 15 seconds
• All Senders
Receive faxes from all senders.
• Special Sender
Receive faxes from the Special
Senders and reject faxes from
all other senders.
• Not Special Sender
Reject faxes from the Special
Senders and receive faxes from
all other senders.
Default: [All Senders]
• Off
• Duplex Portrait: T to T
• Duplex Portrait: T to B
Default: [Off]