Daikin RXYQ96PYDN Service Manual page 320

SiUS34-801A_b
(5) Optional Output Switching
Using this setting, operation output signal and abnormal output signal can be provided. Output
signal is output between terminals K1 and K2 of customized wiring adapter, an optional
accessory.
(6) External ON/OFF input
This input is used for ON / OFF operation and Protection device input from the outside. The
input is performed from the T1-T1 terminal of the operation terminal block (X1A) in the electric
component box.
Setting Table
(7) Thermostat Switching
Differential value during thermostat ON/OFF control can be changed. For details, refer to 4.1
Thermostat Control while in Normal Operation on page 289.
(8) Air Flow Setting When Heating Thermostat is OFF
This setting is used to set air flow when heating thermostat is OFF.
∗ When thermostat OFF air flow volume up mode is used, careful consideration is required before
Indoor Unit
Mode No. First Code No.
12 (22) 0
Setting Switch
Mode No.
No.
12 (22) 1
Mode No.
12(22)
deciding installation location. During heating operation, this setting takes precedence over (7)
Fan Stop When Thermostat is OFF.
Mode No.
12 (22)
Second Code No.
01
03
04
F2 T1 T2
Forced stop
Input A
Setting Position
No.
01
02
03
First Code No. Second Code No.
2
First Code No. Second Code No.
3
Remarks
Indoor unit thermostat ON/OFF signal is
provided.
Output linked with Start/Stop of remote
controller is provided.
In case of Malfunction Display appears on
the remote controller, output is provided.
Operation by input of the signal A
ON: Forced stop (prohibition of using the
remote controller)
OFF: Permission of using the remote
controller
OFF → ON: Permission of operation
ON → OFF: Stop
ON: Operation
OFF: The system stops, then the applicable
unit indicates [A0]. The other indoor
units indicate [U9].
Differential value
01
02
01
02 Preset air flow
Field Setting
1.8°F
0.9°F
Contents
LL air flow
305