Rip Input - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
Example
# Specify the interface Vlan-interface 10 to use the simple authentication with the
authentication key of aaa.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] interface Vlan-interface 10
[3Com-Vlan-interface10] rip version 2
[3Com-Vlan-interface10] rip authentication-mode simple aaa
# Specify Vlan-interface 10 to use the MD5 cipher text authentication, with the
authentication key of aaa and the packet format of rfc2453.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] interface Vlan-interface 10
[3Com-Vlan-interface10] rip version 2
[3Com-Vlan-interface10] rip authentication-mode md5 rfc2453 aaa

2.1.15 rip input

Syntax
rip input
undo rip input
View
Interface view
Parameter
None
Description
Use the rip input command to enable an interface to receive RIP packets.
Use the undo rip input command to disable an interface from receiving RIP packets.
By default, all interfaces, except loopback interfaces, can receive RIP packets.
This command is used in cooperation with another two commands: rip output and rip
work. Functionally, rip work is equivalent to rip input & rip output. The latter two
control the receipt and the transmission of RIP packets respectively on an interface.
The former command equals the functional combination of the latter two commands.
Related command: rip output, rip work.
Example
# Configure the interface Vlan-interface 10 not to receive RIP packets.
Chapter 2 RIP Configuration Commands
2-14