Primary Accounting - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – AAA, RADIUS, HWTACACS, EAD
Description
Use the nas-ip command to specify the source address for sending HWTACACS
packets so that all packets sent to the TACACS server carry the same source IP
address.
Use the undo nas-ip command to remove the configuration.
By specifying the source address of the hwtacacs packet, you can avoid destination
unreachable packets as returned from the server upon interface failure. The source
address is normally recommended to be a loopback interface address.
By default, the source IP address of the packets is the IP address of the sending
interface.
Related command: display hwtacacs and hwtacacs nas-ip.
Example
# Set the source IP address of the HWTACACS packets sent by the NAS (switch) to
10.1.1.1.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] hwtacacs scheme test1
[3Com-hwtacacs-test1] nas-ip 10.1.1.1

1.3.8 primary accounting

Syntax
primary accounting ip-address [ port ]
undo primary accounting
View
HWTACACS scheme view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal format.
port: Port number of the server, which is in the range 1 to 65535 and defaults to 49.
Description
Use the primary accounting command to configure a primary TACACS accounting
server.
Use the undo primary accounting command to delete the configured primary
TACACS accounting server.
By default, the IP address of TACACS accounting server is 0.0.0.0.
Chapter 1 AAA & RADIUS & HWTACACS
1-60
Configuration Commands