Ip Routing Policy Configuration Commands; Apply As-Path - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – Routing Protocol
Chapter 6 IP Routing Policy Configuration
Note:
The word "router" covered in the following text represent routers in common sense
and Ethernet switches running a routing protocol. To improve readability, this will not
be mentioned again in this manual.

6.1 IP Routing Policy Configuration Commands

6.1.1 apply as-path

Syntax
apply as-path as-number-list
undo apply as-path
View
Route policy view
Parameter
as-number-list: AS number list, in the form of as-number&<1-10>. Here, as-number is
an AS number, which ranges from 1 to 65535, and &<1-10> means you can input 1 to
10 AS numbers in one command.
Description
Use the apply as-path command to add AS number before original AS path in
Router-policy.
Use the undo apply as-path command to remove the added AS number.
By default, AS number is not set.
If the Route-policy matching conditions are met, AS attributes of the transmission
route will be changed by the apply as-path command. A maximum of ten AS
numbers can be added.
Chapter 6 IP Routing Policy Configuration Commands
Commands
6-1