Vpanel Display In The Task Tray; Exiting Vpanel - Roland DWX-51D User Manual

Displaying or Exiting VPanel

VPanel Display in the Task Tray

When the VPanel icon is displayed in the task tray, the status of a connected milling machine is always monitored. The display
of the VPanel icon changes depending on the status of the milling machine. The meanings of the displays are shown below.

Exiting VPanel

6
1. Operation Screen
Indicates that at least one of the connected milling machines is on (is online).
Indicates that all the connected milling machines are off.
Indicates that an error has occurred on at least one of the connected milling machines.
If you hover the mouse pointer over this icon, you can check which machine has the error.
Messages are displayed automatically if an error occurs, during milling, and in similar situa-
tions. Even after the message disappears, if you hover the mouse pointer over this icon, the
status of each connected machine (such as Ready, Milling, Finished, Completed, or Offline)
will be displayed.
Messages prompting you to perform maintenance (such as "Spindle run-in required") will
also be displayed. In these situations, perform the maintenance work indicated by the mes-
sage.
Right-click on in the task tray and click [Exit].