Roland DWX-51D User Manual page 61

Error number Message
The % milling bur
might be broken.
101E-****
(% may be "1 to
10")
T h e % m i l l i n g
bur chucking has
101F-**** slipped out.
(% may be "1 to
10")
The % milling bur
is too long.
1020-****
The % milling bur
1021-****
is too short.
(% may be "1 to
10")
The % milling bur
is not found.
1022-****
(% may be "1 to
10")
Situation/error cause
The milling bur might be
broken.
The milling bur holder
might be out of position.
The milling conditions
may be excessively strict.
The collet may be worn
out.
The collet may have
come loose.
The milling conditions
may be excessively strict.
The collet may be worn
out.
There is a possibility
that the position of the
milling bur holder is not
correct.
The milling bur has
not been set or it may
have been mounted
on an incorrect stocker
number.
There is a possibility that
the ATC magazine is out
of position.
The collet may be worn
out.
Responding to Error Messages
Action
1. Press and hold the operation button on the
built-in panel to clear the error.
2. If the milling bur is broken, replace it with a
new one.
3. If the position of the milling bur holder is not
appropriate, correct the position.
P. 26"STEP 2: Attaching the Milling Bur"

1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Review the CAM settings and the shape
specified in the CAD data.
If the error occurs again even after you perform
the above operations, the collet may have
worn out, leading to a decrease in its retention
capabilities. Replace the collet with a new one.
1. Press and hold the operation button on the
built-in panel to clear the error.
2. Retighten the collet.
P. 41"Retightening the Collet"

1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Review the CAM settings and the shape
specified in the CAD data.
If the error occurs again even after you perform
the above operations, the collet may have
worn out, leading to a decrease in its retention
capabilities. Replace the collet with a new one.
Replace the milling bur with one of the appropri-
ate length (40 to 55 mm). Also check the position
of the milling bur holder.
P. 26"STEP 2: Attaching the Milling Bur"

1. Set the milling bur in the correct position
again.
If milling is in progress
Close the front cover, and press and hold the
built-in panel's operation button. Resume
milling.
Perform automatic correction.
P. 38"Correcting the Milling Machine"

Replace the collet.
If the error occurs again even after you perform
the above operations, replace the spindle unit
with a new one.
4. Troubleshooting
61