Roland DWX-51D User Manual page 62

Responding to Error Messages
Error number
1023-0000
1024-0000
1025-0000
1026-0000
1027-0000
1028-0000
1029-0000
102A-0000
102B-0000
102D-0000
1030-0000
103B-0000
62
4. Troubleshooting
Message
Milling data error.
T h e n u m b e r o f
p a r a m e t e r s i s
incorrect.
Milling data error.
The parameter is There may be a problem
out of range.
with the milling data
received from the com-
Milling data error.
puter.
A wrong command
is detected.
<When using Intelligent
Tool Control>
Milling data error.
When using CAM to se-
The address is not
lect the stocker number,
defined.
the stocker number set
as the second milling bur
Milling data error.
in Intelligent Tool Control
The parameter is
has been selected.
not defined.
Milling data error.
T h e o p e r a t i o n
c a n n o t b e
executed.
T h e s p i n d l e
The spindle stopped un-
experienced an
der a large milling load
overload.
or other cause. The fol-
lowing are likely reasons.
T h e s p i n d l e
• The milling bur is worn.
e x p e r i e n c e d
• A workpiece that can-
overcurrent.
not be milled by the ma-
chine is being used.
The spindle motor
• The milling conditions
t e m p e r a t u r e i s
are too strict.
high.
The cable may be broken
The spindle does
or the spindle unit may
not turn.
be defective.
M ake sure the dust
The dust collector
collector is connected
is not working.
correctly and the power
is on.
Automatic correction
may not have been
performed.
Automatic correction
may have been cancelled
before it could finish.
Automatic correction
T h e a u t o m a t i c
may not have been
correction is not
p e r f o r m e d
yet finished.
updating the firmware
to a version that required
automatic correction to
be performed again.
The VPanel and machine
firmware versions may
not match.
Situation/error cause
a f t e r
Action
1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Check the milling data.
If there is no problems with the milling data,
restart the computer, and then perform mill-
ing again.
<When using Intelligent Tool Control>
When using CAM to select the stocker number,
do not select the stocker number set as the
second milling bur in Intelligent Tool Control.
P. 30"Automatically Switching Out the Worn Milling

Bur (Intelligent Tool Control)"
1. Turn off the power.
2. Check the milling bur, the workpiece, and the
CAM settings as well as the shape specified in
the CAD data.
3. Allow the machine to rest for some time be-
fore turning the power on because the motor
may have overheated.
Turn off the power and contact your authorized
Roland DG Corporation dealer.
Turn the dust collector on, and check the dust
collector settings and the filter.
1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Perform automatic correction.
P. 38"Correcting the Milling Machine"

Download the latest versions of VPanel and the
machine's firmware from our special Easy Shape
website (http://www.rolandeasyshape.com),
and then install these versions.