A Hole Opens In The Milling Results - Roland DWX-51D User Manual

Milling Quality Problems
Is the thickness specified in the
CAD data excessively thin?
Recommended CAD data thickness
Unit:mm
1.0 to 1.2
0.4 or
higher
0.6 or higher

A Hole Opens in the Milling Results

Do the milling bur diameter and
ATC magazine number match the
CAM settings?
Is the machine out of correction?
Are the milling conditions too
strict?
52
4. Troubleshooting
Front tooth
1.5 or higher
0.8 or higher
Veneer
1.5 or higher
0.5 to 1.5
If the thickness of workpieces is excessively thin,
chipping is likely to occur. Check the shape specified
in the CAD data.
Molar tooth
1.5 or higher
Onlay
1.0 or higher
Check the CAM's milling bur settings.
The origin point may become out of position due to
prolonged use or relocating the machine, which can
affect milling results. Perform automatic correction.
If expected results cannot be obtained even after
performing automatic correction, perform manual
correction. With manual correction, changing the Z
value in the + direction in Origin point may improve
the situation.
Strict milling conditions may affect milling results.
Review the CAM milling conditions.
1.0 or higher
1.5 or higher
0.8 or higher
Inlay
1.0 or higher
-
-
P. 38
-