Mirror Mode
Mirror Mode
For symmetrical patterns, including products with varying lengths.
To use mirror mode, perform the following steps:
1. Navigate to Event Map, page 29.
2. Verify gun-trigger offset
for the selected gun is greater than or equal to the end of the final bead (final
bead offset + length).
3. Enable mirror mode
for the desired gun.
4. Navigate to Pattern Definition, page 27.
5. Enter bead information for the first half of the product.
6. Enable or disable stitching for each bead.
Material Tracking
The material tracking feature can be used on pattern controllers that are connected to an InvisiPac (internal and inte-
grated systems). See the material tracking section in manual 333347 for more details.
334784G
39