Graco InvisiPac HM25 Operation, Repair, And Parts page 31

Trigger Setup (Screen 3)
1. Select trigger polarity
a. Trigger should show bright yellow when
product is present and dark yellow for no prod-
uct.
b. If polarity is backwards, use the drop-down
to invert the detection.
2. Select trigger line number
a. If product runs past all triggers at the same
speed, select line 1.
A - Enter screen
B - Trigger polarity
C - Line 1 or 2
D - Reset selected counter
E - Lifetime trigger count
F - Resettable trigger count
G - Include in product count
P - Screen number (Screen 3)
Icon Name
Trigger polarity
Select line
Reset counter
Include in product
count
Line Configuration
Single line
Multi-unit line
Multi-line
NOTE: To reset the PC Home product count for each line, reset the current trigger count for the trigger with the dis-
abled (gray) check box.
334784G
:
(PC-8e only):
Toggle polarity to invert state of trigger signal
Select which line the trigger is sensing on (PC-8e only)
Reset trigger cycle count. NOTE: Resetting the first trigger on a given line will reset the
product counter on the PC home screen for the given lion.
Checked - Include trigger cycles in product counter.
Unchecked - Do not include trigger cycles in product counter (see table below).
Diagram
b. Where two line speed settings are required,
select line 1 for triggers sensing from the first
line speed and line 2 for the second.
3. Trigger cycle counters:
a. View current and lifetime cycle counts of each
trigger.
b. Press soft key
of selected trigger.
A
B
C
D
Description
Trigger Setup
Screens
to reset current cycle count
G
E
P
F
PC Home
31