Pc Screens - Graco InvisiPac HM25 Operation, Repair, And Parts

Screens

PC Screens

Home
Read-only view of pattern controller inputs and outputs:
1. Status of guns , triggers
2. Production rate
3. Material dispensed per product
A - Gun states
B - Trigger states
C - Line information
D - PLC signals
Icon Name
Gun
Trigger
Line number Line number for other display values in row
Line speed
Run up
output
%
Production
rate
Product count Total products completed. To configure and reset, see Trigger Setup (Screen 3), page 31.
Glue rate
PLC enable
PLC
disable
Active
program
PLC alarm
24
, and PLC signals.
, and units completed
.
Gun status: active (green), enabled (gray), disabled (crossed out)
Trigger status: active (bright yellow), inactive (dark yellow)
Current line speed (or fixed line speed setting)
Percentage of run up pressure range being output (PC-8e only)
Number of product per minute
Amount of glue per product (integrated InvisiPac systems only). NOTE: For best results,
enter the appropriate specific gravity value for the adhesive material in use (see the Invisi-
Pac system manual).
State of enable signal from PLC
State of disable signal from PLC
Displays the active program chosen by the PLC (displays dashes if the PLC is not selecting
a program)
Alarm status to the PLC (on line 1 or 2)
.
A
B
C
Description
D
334784G