Installation - External Models; Mounting; Connect Advanced Display Module (Adm) - Graco InvisiPac HM25 Operation, Repair, And Parts

Installation - External Models

Mounting

The pattern controller and ADM can be mounted using
the included VESA-compatible brackets and mounting
software.
1. Unscrew the two lower screws to uncouple the
"wall" portion of the bracket.
2. Securely mount the bracket in the desired location.
3. Slide the controller onto the bracket and tighten the
two screws for permanent fastening.
ALTERNATIVE METHOD: Remove mounting hardware
and mount directly to any surface.
NOTE: Make sure at least 13 in. of clearance is avail-
able above the top of the mounting bracket in order to
slide the enclosure in and out of the wall mount.
NOTE: To make repairing the system easier, locate the
system so that it is easily accessible and has sufficient
lighting.
334784G
13 in (330.2 mm)
Clearance
Connect Advanced Display
Module (ADM)
Integrate with InvisiPac HM25c
1. Set pattern control system type selector switch to 0.
NOTE: The system must be powered off for a
change in system type to have an effect.
2. Disconnect the CAN cable from the ADM (D) and
connect it to one of the male ends of the splitter (2).
3. Connect the CAN cable from the pattern controller
enclosure (A) to the other male end of the splitter
(2).
4. Connect the male end of the short CAN cable con-
tained in the pattern controller kit (3) to the female
end of the splitter (2).
5. Connect female end of the short CAN cable (3) to
the ADM.
6. Use zip ties to attach the CAN cables and splitter to
the ADM bracket (B).
Installation - External Models
15