F2: Setting Communications Parameters; Basic Menu For Configuring Communications - Siemens SIMATIC S5 Manual
Hide thumbs
Also See for SIMATIC S5:
- Manual (360 pages) ,
- Equipment manual (197 pages) ,
- Operating instructions manual (43 pages)
Table of Contents
Advertisement
S5-115F Manual
1.1.2
F2: Setting Communications Parameters
Softkey F2 takes you from the COM 115F main menu to the basic menu for "Setting 115F
Communication Parameters".
Setting 115F Communication Parameters
DB No. for progr.operation in safety mode (0; 4 to 255):
Number of SINEC L1 LANs
F1
SUBUNIT
Figure 1-5.
Explanations of Figure 1-5
•
DB No. for parameter entry DB in safety mode ( 4.4)
Enter the block number of your parameter entry DB at this point. You can store process-
specific parameters in this data block using the programmer. The programmer can only be
used in safety mode when the PLC is at STOP.
•
Number of SINEC L1 channels
Specify here if you want to configure a SINEC L1 LAN.
If you configure a SINEC L1 LAN, additional parameters are entered in the form and
interrogated (see Figure 1-6).
EWA 4NEB 811 6149-02
0 means not in use
F2
F3
F4
Basic Menu for Configuring Communications
Configuring with COM 115F
COM 115F / PDC15
0.
(0 , 1 , 2):
0.
F5
F6
F7
SAVE
F8
RETURN
1-13
Advertisement
Table of Contents
